Installing The Bottom Shelf; Securing The Lid Stopper; Installing The Hopper To The Barrel - Pit Boss PB440D Instrucciones

3. INSTALLING THE BOTTOM SHELF

Parts Required:
1 x Bottom Shelf (#19)
4 x Screw (#A)
Locking Washer (#E)
4 x
Washer (#D)
4 x
Installation:
• From underneath, secure the bottom shelf to all each leg using a screw,
locking washer, and washer. Ensure the flat surface of the shelf is facing up.
• Once the shelf is secure, carefully lift the grill into an upright position.

4. SECURING THE LID STOPPER

Parts Required:
1 x Lid Stopper (#3)
Installation:
• Secure the lid stopper onto the top of the main barrel using the
pre-installed screw, locking washer, and washer on the top of the main barrel.

5. INSTALLING THE HOPPER TO THE BARREL

Parts Required:
Hopper Assembly, Plate Screw, Cleanout Plate (#7)
1 x
1 x Probe Wire Casing (#4)
4 x Screw (#A)
4 x Locking Washer (#E)
Washer (#D)
4 x
Installation:
• Secure the plate screw to the cleanout plate, and insert into the
horizontal slit on the rear side of the hopper.
• Align the burn pot end of the hopper assembly into the opening on
the end of the main barrel. Insert only half-way, then carefully slide
the hopper assembly completely into the opening on the end of the
main barrel. Secure the hopper assembly to the main barrel, from the
inside of the barrel, using four screws, locking washers, and washers.
Take care not to over-tighten to avoid stripping the screws. Note
illustration 5A.
• On the rear side of the hopper, connect the silver grill probe
temperature wires – extruding from the main barrel – to the wire
connections from the rear of the hopper assembly. Remove the
two pre-mounted screws. Tuck the excess wire into the probe wire
casing, placing the wire distinctly in the divet along the edge to avoid
pinching. Next, secure the probe wire casing to the hopper using the
two screws previously removed. Note illustration 5B.
IMPORTANT: Ensure the grill probe temperature wires do not get
pinched. Damage to the grill probe temperatures wires may result in
incorrect readings, or inability to funtion.
9
3
A E D
4
5A
REAR VIEW
A E D
5B