Descargar Imprimir esta página

Genie Directlift 2060 Manual De Operación Y Mantenimiento página 11

Ocultar thumbs Ver también para Directlift 2060:

Publicidad

2060-3060 eng.qxd
11/9/05
A
CCESSORIES
Programming 1:
Each Remote Control must be programmed
separately.
The Remote Controls will not cause the door
Opener to close the garage door if the Safe-T-
Beam® System is malfunctioning.
When programming the Remote Controls, they
must be at least 24" from the Antenna Wire.
If the red Learn Indicator Light blinks
approximately 4 times per second,
programming has stopped. If programming
has stopped, repeat the above steps.
Each Button on a 2 or 3 Button Remote Control
is for a different Opener. You cannot use more
than one Button per Remote, per Opener.
A maximum of seven Remote Controls or
Wireless Keypads can be stored into the
Receiver at one time. If a Remote Control
becomes lost, or if you want to delete a Remote
Control or Wireless Keypad, see "To Erase All
Receiver Memory."
A
To program one Button of a Remote Control (Figure 12):
Locate Learn Button and Learn Indicator Light near
Terminal Strip on Power Head (Figure 13).
Press and release Learn Button. Red Learn Indicator
Light will blink 2 times per second.
Press Remote Control Button once within 30
seconds. Red Learn Indicator Light will stay lit.
Press Remote Control Button again. Red Learn
Indicator Light will go out, indicating that
memory is stored.
B
Program each additional Remote using step A above
(up to seven).
To Erase All Remotes from Power Head Memory
A
Press and hold Learn Button on Power Head for 10
seconds or until Learn Indicator Light goes out.
Memory is erased:
Program Transmitter/Receiver again as needed.
To Replace Remote Control Battery
A
FOR NON-FLASHLIGHT MODELS
Pop off the back of the transmitter.
Use coin, pen, screwdriver or any similar device.
Replace old Battery with new coin type battery.
Replace back of remote.
B
FOR FLASHLIGHT MODELS
Slide open battery cover.
Replace old Battery with new AAA battery.
Replace battery cover.
For Help, call 1-800-35-GENIE or visit www.geniecompany.com
11:02 AM
Page 11
C
P
ROGRAMMING THE
R
C
EMOTE
ONTROLS
NOTE
WARNING
A moving garage door may cause serious injury or death.
Keep people clear of opening while door is moving.
Do not allow children to play with the Remote Controls.
If the Safety Reverse does not work properly:
Close the door and disconnect the Opener using the
Emergency Release Cord.
Do not use the door Opener, Remote Controls, or
Wireless Keypad.
Refer to the door and door Opener Owner's Manuals
before attempting any repairs.
Remote Control Operation
A
Press Button on Remote Control. Garage door will move.
B
Press Button again. Garage door will stop:
The door automatically stops at the end of the open or
close cycle.
C
Press Button again. Garage door will reverse.
315 Mhz
Frequency
Switch
390 Mhz
1 Button Compact Remote
w/Docking Station
Figure 12 Genie Remote Controls
Figure 13 Learn Code Button and Indicator Light
D
Some Remote Controls are equipped with a flashlight. The
logo is the button which operates the light. There is a
backlight under the button. When it does not light, it
indicates the battery needs replaced.
Flashlight Button
1 Button Remote
3 Button Remote
w/Flashlight
w/Flashlight
Figure 14 Genie Remote Controls
315 Mhz
Frequency
Switch
390 Mhz
3 Button Compact Remote
w/Docking Station
1 2 3 4
Frequency
Switch
3 Button Large
Remote
w/Flashlight
11

Publicidad

Capítulos

loading