Operation - HAMPTON BAY HB-4305-BK Guía Para El Uso Y Cuidado

Wiring Options (continued)
Wiring motion sensing lights to
4
control each other
IMPORTANT: Total fixture ratings must not exceed 500 Watts (4.2 A).
When wiring so either motion light turns on both
motion lights (Master / Master):
Strip the red wire in both light fixtures.
Connect the red wire of one fixture to the red
wire of the second fixture.
Connect all white wires together.
Connect all black wires together.
Connect all ground wires together.

Operation

1
Setting the sensor for testing
NOTE: When the "ON-TIME" switch is set to the "TEST"
position, the light fixture will operate during the day or
night. The light will stay on for 5 seconds after all motion
is stopped.
Turn the power on at the circuit breaker or fuse
and turn on the wall switch.
Set the "ON-TIME" switch to the "TEST"
position.
Slide the "SENSITIVITY" switch to the "M"
position.
NOTE: The motion sensor (C) will need to completely
warm up (90 seconds) before beginning the setup process.
IT Y
IT IV
N S
S E
I
- H
- M
L O
M IN
1 0
5
E
1
S T - T IM
O N
T E
C
SENSITIVITY
LO - M - HI
TEST 1 5 10 MIN
ON-TIME
NOTE: In most installations, an additional wire (same
gauge as existing house wire) will have to be installed in
the house to connect the two fixtures as master / master.
White to white
Master
Light
Ground to ground
Wiring multiple motion sensing lights
to control each other
Determining the motion sensor
2
coverage area
Perform a "walk test": walk in an arc in front
of the motion sensor (C).
Watch the light. The light will come on when
motion has been detected.
Stop, wait for the light to turn off, and then
begin walking again.
Continue this process until the detection zone
has been established.
8
Red Master
to red
Light
Black to black
C