HAMPTON BAY HB-4305-BK Guía Para El Uso Y Cuidado página 6

Installation (continued)
4
Wiring the light fixture
NOTE: This light fixture can be wired to control another
standard or motion sensing light fixture(s). See Wiring
Options for additional wiring methods.
CAUTION: DO NOT remove wire connector from RED
wire or connect the RED wire unless you want to control
other lights from this motion sensor fixture.
Route the junction box wires through the large
hole in the mounting bracket (HH) and connect
to the wires on the light fixture base (B).
Using the wire connectors (BB):
Connect all white wires together.
Connect all black wires together.
Recommended grounding method: Attach
a copper wire pigtail (1) (not included) to
the green ground screw on the mounting
bracket (HH).
HH
1
5
Mounting the light fixture base
Push the wires into the juction box.
Slide the light fixture base (B) onto the
large mounting screws (GG) and tighten the
decorative mounting nuts (FF) against the
base (B).
Install four candelabra base light bulbs (25
watt maximum each - not included).
See the Operation section for testing and
setup.
After the testing and setup is complete, use the
two decorative fixture nuts (CC) to install the
light fixture cover (A).
White to white
Ground to ground
Two motion sensing lights (working independently)
BB
B
6
Connect all ground wires to the pigtail
wire (1) attached to the green ground
screw.
Black to black
Ground to ground
White to white
One motion sensing light
Light
Black to black
FF
IT Y
IT IV
N S
S E
I
- H
- M
L O
M IN
1 0
5
E
1 -T IM
S T
T E O N
Light
Light
GG
B
CC
A