Installation; Unpacking; Installing Components; Selecting The Location - OHAUS EC Serie Manual De Instrucciones

EC Series

2 INSTALLATION

2.1 Unpacking

Unpack and verify that the following components have been included:
EC Scale
Weighing Platform (plastic base with stainless steel pan)
Instruction Manual
AC Adapter
Save the packaging material. This packaging ensures the best possible protection
for the storage or transport of the product.

2.2 Installing Components

Position the weighing platform pins into the through-holes on the top housing, then
set the platform securely into place. Secure the in-use cover with double-sided tape
as needed.
BEFORE USING THE SCALE, REMOVE THE SHIPPING PROTECTION SCREW
located underneath the scale. This screw ensures protection of the load cell
during transport, but will need to be removed for the scale to operate properly.
It is recommended that the protective screw be re-installed if transporting the
scale. Do not over-tighten the protective screw as it may damage the load cell.
To re-install, turn the scale on and place a 500g weight on the pan, then
slowly screw in the protection screw until the display shows a value between
250g to 400g.

2.3 Selecting the Location

Operate the scale on a firm, level surface. Avoid locations with rapid temperature
changes, excessive dust, moisture, air currents, vibrations, electromagnetic fields,
heat or direct sunlight.

2.4 Leveling the Scale

Adjust the leveling feet until the bubble is centeredin the circle of the level indicator
(located on the front panel).
NOTE: Ensure that the scale is level each time its location is changed.
IMPORTANT:
EN-3