KOBE CH-97 Serie Instrucciones De Instalación Y Manual De Operación página 12

mounting screws (not provided) on the
wall, leaving 1/8" away from the wall.
2. Align hood-mounting bracket to the screws
on the wall and hook hood into place as
shown in Figure 11. Tighten screws to
secure hood to the wall.
3. For safety purposes, extra knockout holes
on the back of the hood are provided.
Knockout the holes. Remove the baffle
filters and attach screws to the wall by
accessing underneath
CAUTION: MAKE
SUCURE BEFORE RELEASING
Wiring to Power Supply
6$)(7< :$51,1*
RISK OF ELECTRICAL SHOCK.
RANGE HOOD MUST
GROUNDED. MAKE SURE THIS IS DONE
BY SPECIALIZED
ACCORDANCE WITH
NATIONAL AND
CODES. BEFORE CONNECTING WIRES,
SWITCH POWER OFF AT SERVICE PANEL
AND LOCK SERVICE PANEL TO PREVENT
POWER FROM BEING
ACCIDENTALLY.
4. Connect the electrical wires.
-
Connect three wires (black, white and
green) to house wires and cap with wire
connectors. Connect according to color:
black to black, white to white, and green
to green as shown on Figure 12.
-
If necessary to hide the electrical wire
connections, push wires back into the
wiring box. Access the wire connections
underneath the hood. Make sure wires
do not slip between motor or any
moving parts to prevent any damage.
Duct Cover Installation
5. Mark the position of the duct cover-
mounting bracket. Use reference E from
Table 2 and measurements on page 16-
17. Attach and secure duct cover-
mounting bracket with two screws (not
provided). Refer to Figure 13. NOTE:
Inner duct cover will cover the duct cover-
mounting bracket.
the hood.
SURE HOOD
THIS
BE PROPERLY
ELECTRICIAN
ALL APPLICABLE
LOCAL ELECTRICAL
SWITCHED
Figure 12
IS
Figure 13
IN
ON
Figure 14
Figure 15
10