Estantes Del Congelador - GE IM-6D Manual Del Propietario E Instalación

Follow the instructions below for the ice tray holder that looks like yours.
• Unhook the ice tray holder side and bottom from
the retaining hooks. Lower the holder until the side
is clear of the freezer shelf and remove it from the
freezer. You will not need this part.
• As you lift the tab on the left side in the holder with
the blade of a screwdriver, pull the holder forward
and out. You will not need this part.
REPOSITION OR REMOVE FREEZER SHELVES
On some models, you may need to remove or reposition the freezer shelf so the icemaker and bucket
sit properly. Follow the instructions below for the ice tray holder that looks like yours.
• To reposition the two-piece shelf supports, slide the
shelf up off the base mount.
Shelf
support
Installation Instructions
REMOVE EXISTING ICE TRAY HOLDER
Type 1
Retaining hooks
Type 2
Do not
lift here
Lift this
tab out
Type 1
Base
mount
• Remove the 2 screws and save them for installation
of the icemaker.
• Lift the ice tray holder off the plastic hook. You will
not need this part.
Screws
Plastic hook
• Remove the screw with a 1/4" nutdriver.
• Pull the ice tray shelf away from the wall. Remove
the shelf. You will not need this part.
• Replace the screw.
• On some bottom-mount no-frost refrigerators, you
need to remove a full width flat freezer shelf before
installing the icemaker.
9
Type 3
Type 4
Screw
Type 2