Prepare For Installation - GE IM-6D Manual Del Propietario E Instalación

ICEMAKER INSTALLATION INSTRUCTIONS T
BEFORE YOU BEGIN
Read each step thoroughly before proceeding.
WARNING
To eliminate the
risk of electric shock or injury during
installation, you must first unplug the
refrigerator before proceeding. Failure
to follow these instructions can result in
electrical shock.
TOOLS YOU WILL NEED
Flat blade and Phillips
screwdrivers

PREPARE FOR INSTALLATION

1
• Remove the storage
basket (on some models)
by pulling it out to the
stop position and lifting
it up and out.
Note: After removing
the basket, push the
into the freezer
compartment.
• Remove the chiller shelf
(on some models) by
pulling it straight out.
• Remove the center
vertical shelf support
(on some models) by
lifting it and rotating
its bottom to the right.
• Inside the freezer,
remove the two small
white plug buttons (on
some models) from the
side wall. (If screws are
present instead of plugs,
leave them in place.)
• Remove and discard
the large white plug
from the rear freezer
wall.
• Remove the outlet cover with a flat-blade
screwdriver.
Installation Instructions
Pliers Sharp knife
Remove side wall
plug buttons or leave
screws in place
Rear wall
plug button
Outlet
cover
SET POWER SWITCH TO OFF
2
Set the icemaker power switch to OFF. Leave
the power switch in the OFF position until the
refrigerator is connected to the water supply to
prevent premature operation.
Power
Switch
(Appearance may vary)
INSTALL THE MOUNTING SCREWS
3
• Skip to Step 4 if screws are already in place in
the freezer side wall.
• Install two self-tapping Phillips
head screws (16) from the kit
in the holes in the side wall.
wall.
INSTALL THE ICEMAKER FILL CUP
4
Install the icemaker fill cup (end-mounted) that came
with your unit into the icemaker as shown. If the fill cup