GE IM-6D Manual Del Propietario E Instalación página 32

INSTALL THE MOUNTING SCREWS
4
• Skip to Step 5 if screws are already in place in
the freezer side wall.
• Install two self-tapping Phillips
head screws (16) from the kit
in the holes in the side wall.
wall.
INSTALL THE ICEMAKER FILL CUP
5
the icemaker as shown.
PLUG IN THE ICEMAKER
6
Holding the icemaker in place, insert the icemaker
power cord plug into the socket on the rear wall,
making sure the prongs and holes are matched.
Press the plug firmly into the socket. Lock the plug in
place by clipping the restraints onto each side of the
plug. Make sure the restraints click into place. Make
sure the power cord is still in the hook on the back
of the icemaker.
Hook
Installation Instructions
MOUNT THE ICEMAKER
7
• Lift the icemaker so the fill tube shipped with the
refrigerator fits in the fill cup opening (E). Hang the
icemaker on the two mounting screws (16) in the
side wall.
Make sure:
• The power cord is still firmly in the socket.
• The fill tube
the back of the icemaker. (Check the rear of the
refrigerator to make sure the fill tube has not
been pushed out of the back of the refrigerator).
• The icemaker mounting screws are located in
the uppermost position of the mounting slots.
• The icemaker is level.
• The icemaker power switch is set to OFF.
THEN SECURELY TIGHTEN THE ICEMAKER
MOUNTING SCREWS.
16
RE-INSTALL THE SHELF SUPPORT,
8
BUCKET, SHELF AND BASKET
Replace the center vertical shelf support, ice bucket,
chiller shelf and storage basket by reversing the steps
in Step 1.
ATTACH WARRANTY LABEL
9
A label (18) is provided with this kit to record the
date of installation for warranty purposes. Apply it
to the back of the refrigerator.
KEEP THIS MANUAL
10
The warranty for the icemaker is printed in this
manual. Keep this manual with your Refrigerator
Owner's Manual.
The icemaker installation inside the freezer is now
complete. Continue to the Water Valve Assembly
section.
E