Dc Recharging Of The Psx2; Use Of The Psx2; Jumpstarting Precautions - PowerStation PSX2 Manual Del Propietário

OPERATION
To Recharge using a 12V DC power source:
(Do not exceed 2 hours)
Note: Only use the DC charging option when an AC power source is not
available.
1. Insert the DC charging cord into the cigarette lighter receptacle on
the boat or vehicle.
2. Insert the other end of the DC charging cord into either one of the
12V DC power outlets on the side of the unit.
Note: The jumpstart on/off switch can be left in the off position.
It is possible to over charge the battery when re-charging using
the DC outlet. Over charging the battery can cause permanent
CAUTION
damage and decrease battery performance. Only charge using
DC supply if a 120V AC outlet is not available. Do not exceed 2
hours of DC charge time.

USE OF THE PSX2

The following section will guide you through the use
of your PSX2.
Please note that while using various features of the PSX2 simultaneously is
permissible, this will increase the load on the battery, thereby reducing run-time
before recharging is necessary.

Jumpstarting precautions

RISK OF FIRE, EXPLOSION OR BURNS.
Electrolyte inside lead acid batteries contains sulfuric acid which
can burn skin and harm or destroy clothing. Wear eye
protection any time you are jumpstarting a battery and keep
baking soda mixed with water available to neutralize acid. Make
WARNING
sure that long hair is put up securely, do not wear loose fitting
clothing or jewelry, these could become caught in moving
engine parts or create a short circuit resulting in personal injury
or loss of life.
030211
continued
PSX2 Owners Manual Page 9