Using The Jumpstart - PowerStation PSX2 Manual Del Propietário

USE OF THE PSX2

Using the Jumpstart

The PSX2 can be used to jumpstart any standard size vehicle or boat with
a single 12V starting battery. If you have any questions regarding how to jump
start your vehicle, consult the vehicle owners manual or the vehicle manufac-
turer before using the PSX2 jump start function.
The following steps should be read completely before starting this
procedure and then carefully followed throughout the procedure:
1. Be sure that the PSX2 jumper cables power switch is in the OFF
position (see Figure 2 on page 7 for location P).
2. Ensure safety of immediate area. See warnings at the beginning
of this manual for further details.
3. Turn off the vehicle or boat, as well as all attached accessories such
as lights, radios, et cetera.
4. Be sure that the emergency brake is engaged. Manual transmission
vehicles should be in neutral. Automatic transmission vehicles
should be in park.
5. If jumpstarting a boat engine, purge the engine compartment and
vent fumes per boat manufacturer instructions before proceeding.
6. Position the PSX2 on a secure, level surface in reach of the battery
but away from all electrical and moving parts of the engine. Please
note, some engine components may be hot enough to cause severe
burns or damage the PSX2.
7. Connect the red positive (+) clamp (see Figure 2 on page 7 for location
N) of the PSX2 to the positive (+) terminal of the battery (never lean
over the battery when making connections to jumpstart).
8. Connect the black negative (-) clamp (see Figure 2 on page 7 for
location O) of the PSX2 to the engine block, cylinder head, or other
heavy, yet stationary metal engine part.
WARNING
030211
If cables are attached to the incorrect battery terminal the
Cables Reversed LED (see Figure 2 on page 7 for location Q)
will switch on and a warning tone will sound. If this occurs,
correct the connection before proceeding to the next step.
Failure to do so may cause sparking, personal injury and/or
harm to the vehicle or jumpstart unit. Check to be sure that
the cables are clear of all moving engine parts.
continued
PSX2 Owners Manual Page 11