Troubleshooting - BM2 BIEMMEDUE MODULA 130.10 Manual De Uso Y Mantenimiento

10 Table of regular maintenance
OPERATION
Check the functioning of all
controls
Check connector gaskets
Check oil level in the pump
11

Troubleshooting

The table below gives the most common problems which may arise
during normal use of the high pressure washer.
These problems are easy to resolve with operations classified as
routine maintenance If the problem is not present in the following
table or cannot be eliminated following the instructions here, contact
customer service.
PROBLEM
The machine does
not start up
Motor does not start
but makes a noise
Inadequate
pressure
Vibrations and/or
abnormal water
discharge
Pump noisy
"White" oil
Water leaks
X
X
X X
CAUSE REMEDY
Electrical power Check
supply absent or characteristics of the
inadequate power line
Electrical Contact
protection service
tripped
Inadequate Check
voltage characteristics of the
power line
Nozzle blocked Clean or replace
or distorted
Valve dirty or Contact
worn service
The pump is Check water supply
sucking in air connectors
Air in the hoses Vent the
disconnecting
hose
Pump gaskets Contact
worn service
Suction delivery Unscrew valve caps,
valves blocked remove and clean
(ideally
customer service)
Bearings worn
Contact
service
Seepage of Have the seal pack
water into the oil replaced
(emulsion) customer service
Gaskets and/or Have the seal pack
pistons worn replaced
customer service
the
customer
the
customer
air by
the
customer
contact
customer
by
by