Technical Data; Important Installation Information - MAC Audio EDITION S MONO El Manual Del Propietario

Dear MAC AUDIO Customer,
The EDITION S MONO car hi-fi power amplifier will enable you to satisfy your high demands on sound
reproduction in your car. With its impressive deep-bass power reserves, low harmonic content and
neutral reproduction, the EDITION S MONO takes car hi-fi to new heights. The amplifier is characterized
by low operating current, rapid switching capabilities and excellent temperature stability. Experience and
enjoy how this high-tech machine perfectly reproduces magnificent sound.
Intended use
This device is only suitable for installation in motor vehicle with 12 volt supply voltage and negative
ground.
Please read all of the owner's manual before installing and using the amplifier.
1.

TECHNICAL DATA

Max. output power (1 kHz sinus burst 2:8, B+=14.4V)
Nominal output power (DIN 45 324, B+=14.4V)
Max. output power (1 kHz sinus burst 2:8, B+=14.4V)
Nominal output power (DIN 45 324, B+=14.4V)
Loudspeaker impedance
Frequency response
Total harmonic content (DIN 45 403)
Weighted noise distance (IEC A)
Input sensitivity LOW LEVEL INPUT
Input impedance LOW LEVEL INPUT
Low-pass filter
Subsonic filter
Bass boost
Supply
Fuse
Sizes (W x H x D)
Weight
SUBJECT TO TECHNICAL CHANGE
2. FEATURES
· Complementary push-pull final stage
· Stable at 2 ohms
· Low-pass (subwoofer) and subsonic filter with infinitely adjustable separating frequencies
· Infinitely variable bass equalisation
· Adjustable input sensitivity
· Electronic protective circuit against short circuiting, DC offset and excess temperature
· Mute switch for suppressing switch-on crackle interference
· Low-level outputs (cinch jacks) for connecting additional amplifiers
· Remote control for volume control
3.

IMPORTANT INSTALLATION INFORMATION

· This appliance may only be connected to a 12 volt system with negative ground.
· The heat radiated when the amplifier is used means that sufficient air circulation is required at the
place of installation. It is very important that the cooler's cooler ribs do not contact any metal plating
or any surfaces which could impair air circulation. The amplifier may not be installed in small confined
spaces or spaces without air circulation (e.g. spare wheel recess or under the vehicle carpeting).
Installation in the boot is recommended.
EDITION S MONO
800 W on 4 Ohm
225 W on 4 Ohm
1400 W on 2 Ohm
350 W on 2 Ohm
2 – 8 Ohm
10 – 300 Hz (-3 dB)
< 0.08 % (100 Hz)
> 100 dB
0.4 – 6 V
20 kOhm
40 – 300 Hz, 12 dB per octave
10 – 40 Hz, 12 dB per octave
0...12 dB at 45 Hz
+12 V (10 – 15 V), minus to ground
2 x 25 A
327 x 53 x 236 mm
3.1 kg
7