Publicidad
Idiomas disponibles
Idiomas disponibles
SAFETY INFORMATION
WARNING
•
ELECTRICAL SHOCK ALERT.
Do not disassemble the motor housing. The motor has NO repairable internal parts and
disassembly may cause dangerous electrical wiring issues.
•
ELECTRICAL SHOCK ALERT.
Before installing this product, have the electrical circuit checked by an electrician to ensure proper
grounding. All electrical installations must conform to the National Electric Code and all local codes.
•
ELECTRICAL SHOCK ALERT.
Connect the controller to a properly-grounded 115 volt circuit equipped with a Ground Fault Circuit
Interrupter (GFCI) device. Make sure the electrical supply circuit is equipped with fuses or circuit
breakers with a minimum capacity of 15 amps.
•
ELECTRICAL SHOCK ALERT.
Never use an extension cord.
•
ELECTRICAL SHOCK ALERT.
Do not remove or replace the power cord.
•
ELECTRICAL SHOCK ALERT.
Protect electrical cord from sharp objects, hot surfaces, oil, and chemicals. Avoid kinking the cord.
•
ELECTRICAL SHOCK ALERT.
Do not lift pump by the power cord.
•
PERSONAL INJURY ALERT.
Do not touch an operating motor housing. The motor is designed to operate at high temperatures.
•
PERSONAL INJURY ALERT.
Release all pressure and drain all water from the system before servicing any component.
•
PERSONAL INJURY ALERT.
Secure discharge line before starting pump. An unsecured discharge line can cause personal injury
and/or property damage.
•
PERSONAL INJURY ALERT.
Wear safety glasses at all times when working with pumps.
•
PROP65 WARNING FOR CALIFORNIA RESIDENTS:
Cancer and Reproductive Harm – www.P65Warnings.ca.gov
CAUTION
•
PERSONAL INJURY OR PRODUCT DAMAGE MAY RESULT.
The controller operates on 115 volts. Make certain that the power source conforms to the
requirements of your equipment.
•
PRODUCT DAMAGE MAY RESULT.
The continuous operating water temperature for this pump must not exceed 104°F (40°C).
•
PRODUCT DAMAGE MAY RESULT.
This pump is designed to pump water only. It has not been evaluated for pumping chemicals or
corrosive materials. This pump is not designed for pumping effluent or sewage and should not be
used in applications involving salt water or brine.
•
PRODUCT DAMAGE MAY RESULT.
Inspect the pump regularly for damage and perform routine maintenance as needed. Remove any
debris that may build up around the float.
•
PRODUCT AND/OR PROPERTY DAMAGE MAY RESULT.
This pump is not designed for continuous operation.
3
© 2020. All rights reserved.
Publicidad
