Zoeller SENTRY STBB300 Manual Del Usuario página 7

INSTALLATION INSTRUCTIONS
7. Use the included anchors to install the
controller. For best cooling, attach to wall. The
controller must be installed at least 3 ft. above
the sump pit.
8. Place the battery inside the battery box and connect
the leads from the controller to the battery terminals.
Connect positive (+) lead to positive terminal on the
battery and black negative (-) lead to the negative
battery terminal.
NOTE: If wires are not connected properly, a loud,
constant audible alarm will sound until the leads are
attached to the correct terminals.
9. Connect backup pump and float leads to the
controller
7
8
9
7
© 2020. All rights reserved.
Anchors
AC FLOAT
POWER STATUS
24/7 BASEMENT
PROTECTION
DC
BATTERY
PUMP
USB
1-800-584-8089
DC
BasementSentry.com RESET FLOAT PUMP
To controller
P L A T I N U M
AC FLOAT
POWER STATUS
24/7 BASEMENT
PROTECTION
DC
BATTERY
PUMP
USB
1-800-584-8089
DC FUSE
BasementSentry.com
RESET FLOAT PUMP 30 AMP
From float
From
backup
pump
by
TEST
SILENCE
DC POWER
FUSE + 15V DC 1.6A
30 AMP
Controller
Minimum
3 ft.
Sump
Basin
by
TEST
SILENCE
From battery