Publicidad
Idiomas disponibles
Idiomas disponibles
PRINCIPLES OF OPERATION
Oscillation frequency 20 000 rpm at 2.8° angle allows to work precisely in small areas and corners with the
power tool.
SAWING AND CUTTING
Use only undamaged working tools in good technical condition.
When sawing or cutting wood, fibre board, wood-based materials etc. make sure they do not contain
foreign objects like nails, bolts etc before starting the task. Remove foreign objects or use proper
blade for removal. You can make plunge cuts only in soft materials like wood, gypsum boards and
alike.
Cutting ceramic tiles causes faster wear of working tool.
SANDING
Working efficiency in surface sanding depends mainly on type and quality of sanding paper and pressure
applied for processing. Overpressure does not make sanding more efficient, it only causes faster wear of
sanding paper and may cause overheating of the power tool. Apply moderate and uniform pressure.
You can use tip or edge of the sanding pad to sand corners or edges in hardly accessible places.
Proceed with sanding tasks only with dust extraction system connected. Do not use paper previously
used for metal polishing for processing material of other type.
SCRAPING
Scrape soft materials (e.g. wood) at small angle and with small pressure.
Otherwise the scraper can damage the surface.
Unplug the power cord from mains socket before commencing any activities related to installation,
adjustment, repair or maintenance.
● Always keep the tool clean.
●
Do not use water or any other liquid for cleaning.
●
Use a brush or a dry piece of cloth to clean the power tool.
●
Clean working tools with a wire brush.
●
Clean ventilation holes regularly to prevent motor overheating.
●
In case of excessive commutator sparking, have the technical condition of carbon brushes of the motor
checked by a qualified person.
●
Store the tool in a dry place, beyond reach of children.
REPLACEMENT OF CARBON BRUSHES
Replace immediately worn out (shorter than 5 mm), burnt or cracked motor carbon brushes. Always
replace both carbon brushes at a time.
Entrust replacement of carbon brushes only to a qualified person. Only original parts should be
used.
All defects should be repaired by service workshop authorized by the manufacturer.
RATED PARAMETERS
Parameter
Supply voltage
Input current frequency
Rated power
Idle oscillation speed
Oscillation angle
OPERATION AND MAINTENANCE
TECHNICAL PARAMETERS
Multi Purpose Tool
14
Value
230 V AC
50 Hz
180 W
-1
20 000 min
2.8°
Publicidad
