Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
E N G L I S H
2
Conductor size (mm
)
0.75
1.00
1.50
2.50
4.00
Voltage
Amperes
115
0 - 2.0
2.1 - 3.4
3.5 - 5.0
5.1 - 7.0
7.1 - 12.0
12.1 - 20.0
230
0 - 2.0
2.1 - 3.4
3.5 - 5.0
5.1 - 7.0
7.1 - 12.0
12.1 - 20.0
Assembly and adjustment
Prior to assembly and adjustment always
unplug the tool.
Selecting the operating mode (fig. B)
The tool can be used in two operating modes:
Rotary drilling:
for steel, wood and plastics.
Percussion drilling:
simultaneous rotating and impacting for
concrete and masonry drilling
operations.
• Select the required operating mode by rotating
the mode selector (4) to the required position.
Inserting and removing a bit (fig. A)
Keyless chuck
• Open the chuck by turning the sleeve (9)
counterclockwise and insert the bit shank.
• Tighten firmly by turning the sleeve clockwise.
20
Cable rating (Amperes)
6
10
15
20
25
Cable length (m)
7.5
15
25
30
45
Cable rating (Amperes)
6
6
6
6
6
6
6
6
15
6
6
10
15
20
10
10
15
20
20
15
15
20
25
25
20
20
25
-
6
6
6
6
6
6
6
6
6
6
6
6
10
10
10
10
10
15
15
15
15
15
20
20
20
20
20
25
Keyed chuck
• Open the chuck by turning the sleeve (9)
counterclockwise and insert the bit shank.
• Put the chuck key (10) into each hole in the side
of the chuck and turn clockwise until tight.
• To remove the bit, proceed in reverse order.
Fitting the side handle (fig. A)
60
The side handle (6) can be fitted to suit both
RH- and LH-users.
6
10
15
20
25
-
• Loosen the side handle.
-
-
• For RH-users, slide the side handle clamp over
6
6
the collar behind the chuck, handle at the left.
6
6
• For LH-users, slide the side handle clamp over
15
the colar behind the chuck, handle at the right.
15
• Rotate the side handle to the desired position
20
and tighten the handle.
-
Setting the drilling depth (fig. C)
• Insert the required drill bit into the chuck.
• Slacken the side handle (6).
• Fit the depth adjustment rod (7) through the hole
in the side handle clamp.
• Adjust the drilling depth as shown.
• Tighten the side handle.
Forward/reverse slider (fig. A)
• To select forward or reverse rotation, use the
forward/reverse-switch (3) (see arrow on tool).
Chuck removal (fig. D & E)
• Open the chuck jaws as far as possible.
• Insert a screwdriver into the chuck and remove
the chuck retaining screw (12) by turning
clockwise.
• Tighten an Allen key into the chuck and strike it
with a hammer as shown.
Always use the drill with the side handle
properly assembled.
Always wait until the motor has come to
a complete standstill before changing the
direction of rotation.
Publicidad
Tabla de contenido
