5.
Set alarm sound volume
If you prefer:
Press
No sound
A low beep
A louder beep
6.
c
Press
and repeat 2, 3, 4 and 5 to set remaining reminder alarms or
7.
m
Press and hold
for 3 seconds until meter turns off.
Transferring Test Results To a Computer
appears on the display when you insert a data cable in the data port. The computer
must have a compatible data management system to complete the transfer. Remove
this cable before performing a test.
Contact Customer Care to learn more about the data management system.
31
Contact Customer Care Toll Free at 1-888-522-5226 www.MyFreeStyle.com
ART22812-003_rev-A.indd 31-32
All manuals and user guides at all-guides.com
c
until you see:
Then
•
m
Press
to save
Maintaining the Meter
Replacing the Battery
The meter comes with a #2032, 3-volt, lithium battery installed. It provides power for about
1000 tests.
•
When
appears on the display, the battery is low.
•
When
appears, the meter may fail to turn on.
•
When you are
IMPORTANT: When
appears, replace the battery immediately.
ready to install
a new battery,
remove the old battery and install the new battery within 60 seconds to avoid losing time
and date settings.
•
If time and date settings are lost, both time
Reset time and date to get the correct 7-, 14-, and 30-day averages. If the time and date
settings are lost, you may still perform an accurate blood glucose test.
•
Memory log and previously stored user settings, such as date and time format, are not
affected by removing the battery.
and date
will flash until reset.
32
11/10/16 11:02 AM