Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 75

8. Operating Instructions

1.
Always switch OFF the device when it is not in use..
2.
If "OL" or "1" is displayed while measuring the value exceeds the used
range. Switch to a higher range if available.
Note: Due to the high sensitivity the reading sometimes shows random
values if the test leads are not connected to any signal. The reading
stabilizes when the test leads are connected to the circuit to be tested.
Devices like welding transformer, car ignition system, etc. could produce stray
electromagnetic fields which could adulterate the result of a measurement.
DC Voltage measurement
Attention: Avoid voltage measuring in electrical circuits while motors are
switched on or off. The stress-spikes can damage the instrument.
1.
Set the rotary switch to the V
2.
Attach the pin-plug of the black test lead to the COM-jack and the
pin-plug of the red test lead to the V-, A-, Ω-jack.
3.
Connect the black test prod to the negative pole and the red test prod to
the positive pole of the circuit to be tested.
4.
Once the reading stabilizes, read the value. If the polarity is twisted a
"Minus sign" is displayed. Use the HOLD function if the reading is difficult
to read.
- Position
DC
EN 10

Publicidad

Tabla de contenido
loading

Tabla de contenido