Publicidad
Idiomas disponibles
Idiomas disponibles
11.
If your measurement is greater than the Allowable
GB
Distance Between Marked Lines for the corresponding
Ceiling Height in the following table, the laser must be
serviced at an authorized service center.
Ceiling Height
2.5m (8')
3m (10')
4m (14')
6m (20')
9m (30')
90º Between Vertical Beams
Checking 90º accuracy between the front and side vertical
beams requires an open floor area at least 6m x 3m (20' x 10').
1.
Place the laser on a smooth, flat, stable surface that is
level in both directions, as shown in Figure
2.
Turn the laser ON.
3.
Press
three times to display the front and side vertical
beams.
4.
Press
twice to display the down dot.
5.
Along the front laser beam, mark three locations
, and
; where
b
c
6.
Position the laser so the down dot is over
laser beam is aligned with
7.
Mark a location
(10') away from the laser.
8.
Turn the laser clockwise 90º.
9.
Position the laser so the down dot is over
laser beam is aligned with
10.
Along the side laser beam, mark
11.
Measure the distance between
12
Allowable Distance
Between Marked Lines
1.5mm (1/16")
2.0mm (3/32")
2.5mm (1/8")
4mm (5/32")
6mm (1/4")
H 1
is at the midpoint of the laser beam.
b
b
(Figure
c
H 2
along the side laser beam at least 3m
e
b
(Figure
e
H 3
near
f
a
and
.
a
f
12.
If your measurement is greater than the Allowable
Distance Between
Distance from
must be serviced at an authorized service center.
Distance from
b
3m (10')
4m (14')
5m (17')
6m (20')
7m (23')
Using the Laser
Operating Tips
• Always mark the center of the beam created by the laser.
.
• Extreme temperature changes may cause movement of
internal parts that can affect accuracy. Check your accuracy
often while working.
• If the laser is ever dropped, check to make sure it is still
calibrated.
• As long as the laser is properly calibrated, the laser is self-
,
a
leveling. Each laser is calibrated at the factory to find level as
long as it is positioned on a flat surface within average ± 4°
of level. No manual adjustments are required.
and the front
).
• Use the laser on a smooth, flat, level, surface.
Turning the Laser Off
Slide the Power/Transport Lock switch to the OFF/Locked
position (Figure
and the front
switch is not placed in the Locked position, the laser will not
).
turn off.
.
Using the Laser with Accessories
WARNING:
Since accessories other than those offered by
Stanley have not been tested with this laser, use of
such accessories with this laser could be hazardous.
&
for the corresponding
a
f
to
in the following table, the laser
b
a
Allowable Distance
to
Between
a
3.2mm (1/8")
3.5mm (5/32")
4.5mm (3/16")
5.5mm (7/32")
6mm (1/4")
) when the laser is not in use. If the
A 1
&
a
f
Publicidad
