Preparing The Media - Panasonic SC-PM602 Instrucciones De Funcionamiento

Preparing the media

Disc
1
Press [CD x] (main unit: [x OPEN/CLOSE]) to open
the disc tray.
Put in a disc with the label facing up.
Press again to close the disc tray.
2
Press [USB/CD] to select "CD".
USB
1
Decrease the volume and connect the USB device
to the USB port.
Hold the main unit when connecting or disconnecting
the USB device.
2
Press [USB/CD] to select "USB".
Note:
Do not use a USB extension cable. The system cannot
recognise USB device connected through a cable.
®
Bluetooth
You can connect and play an audio device wirelessly
through Bluetooth .
®
Preparation
• Switch on the Bluetooth
the device near the system.
• Read the operating instructions of the device for
details.
█
Pairing a device
Preparation
If this system is connected to a Bluetooth
disconnect it (Z"Disconnecting a device").
1
Press [ ].
If "PAIRING" is shown, continue with step 3.
2
Press [PLAY MENU] to select "PAIRING" and then
press [OK].
Or press and hold [
until "PAIRING" is shown.
3
Select "SC-PM602" from the Bluetooth
the device.
If prompted for a passkey, input "0000".
The device connects with this system automatically
after pairing is complete.
The name of the connected device is shown for a few
seconds.
Note:
You can pair up to 8 devices with this system. If a 9th device
is paired, the device that has not been used for the longest
time will be replaced.
® feature of the device and put
® device,
–PAIRING] on the main unit
® menu of
█
Connecting a device
Preparation
If this system is connected to a Bluetooth
disconnect it (Z"Disconnecting a device").
1
Press [ ].
"BLUETOOTH READY" is shown.
2
Select "SC-PM602" from the Bluetooth
the device.
The name of the connected device is shown for a few
seconds.
3
Start playback on the device.
Note:
• A device must be paired to connect.
• This system can only connect to one device at a time.
"BLUETOOTH"
• When is selected as the source, this
system will automatically try to connect to the last
connected device. ( "LINKING" is shown during this
process.)
█
Disconnecting a device
1
Press [ ].
2
Press [PLAY MENU] repeatedly to select
"DISCONNECT?".
3
Press [R, T] to select "OK? YES" and then press
[OK].
"BLUETOOTH READY" is shown.
To cancel, select "OK? NO".
Using the main unit
Press and hold [ –PAIRING] until "PAIRING" is
shown.
Note:
A device is disconnected when you:
• Select a different source.
• Move the device out of the maximum range.
• Disable the Bluetooth ® transmission of the device.
• Switch off the system or the device.
® device,
menu of
®
5
5