Troubleshooting
No Audio When Using a BluRay Player
Ensure the audio settings in the BluRay player are configured to play Dolby Digital. The DSS2 is not DTS compatible. If the DSS2 is connected to
a digital source with a DTS signal, then the DSS2 will not receive audio.
No Sound When Using a Digital Connection
Ensure the digital cable is connected properly and receiving a signal. When connected to a console, PC, etc. that is powered on, carefully check
to see if a red light is being emitted from the end of the digital optical cable. Also be sure that the protective covers have been removed from the
ends of the digital optical cable.
No Surround Sound on PC
Most games will not output Dolby 5.1 unless your computer is running Dolby Digital Live. You will hear enhanced audio stereo unless Dolby
Digital Live is installed.
Analog Input isn't Working
The DSS2 analog input will automatically shut off whenever the digital input is active. To hear the analog input signal, either
disconnect the optical cable from the digital input on the DSS2, shut off the device connected to the optical cable (e.g. Xbox 360) to disable the
digital audio signal, or connect to the auxiliary input.
15
Technical Specifications
P11 Headset
• 50mm diameter speakers
• Speaker Frequency Response: 20Hz - 20kHz, >120dB SPL @ 1kHz
• Condenser Microphone Frequency Response: 50Hz - 15kHz
• Cable length: 16 ft.
P11 Amplifier
• Stereo DC-coupled, 35mW/ch, THD <1%, Frequency Response: DC - 30kHz
• Bass Boost fixed: +6dB @ 50Hz
• Mic mute switch
• Maximum analog input level with volume control on maximum setting: 2Vpp (700mV rms)
GAME
CHAT
• 3.5mm plug for line input
• USB connector for power (5VDC @ <60 @ mA max)
DSS2 Surround Sound Processor
• Game audio frequency response: 20Hz - 20kHz, >120dB SPL @ 1kHz
• Headphone amplifier: Stereo 35mW/ch, THD <1%
• Digital Audio Input: TOSLINK connector compatible with 48kHz Digital Audio Streams
• Maximum Analog Input: 2Vpp (700mV rms)
• USB connector for power (5VDC @ <380 @ mA max)
16