Setup 5: Bundle The Cords And Cables; Setup 6: Turn On The Monitor And Computer - Sony SDM-X52 Manual De Instrucciones

Setup 5: Bundle the cords and
cables
1
Remove the arm cover.
2
Bundle the cords and cables inside of the stand.
3
Secure the cables and cords with the cable holder.
4
Replace the arm cover and back cover.
3
Note
If you cannot bundle all of the cords and cables inside the stand, leave
them hanging down outside the stand.
1
arm cover
Hold at this
point.
2
4
back cover
Setup 6: Turn on the monitor and
computer
1
Press the MAIN POWER switch on the left side of the
monitor in the direction of [.
The 1 (power) indicator lights up in red.
MAIN POWER
2
Press the 1 (power) switch on the front right of the
monitor.
The 1 (power) indicator lights up in green.
3
Turn on the computer.
4
Press the INPUT button repeatedly and select the
desired input signal.
The selected input signal indicator lights up and the picture
appears on the screen.
For more information, see "Selecting the input signal (INPUT
button)" on page 11.
The installation of your monitor is complete. If necessary, use the
monitor's controls to adjust the picture (page 12).
lights in red
GB
lights in green
(continued)
9