Assembly - Hanging the Fan (continued)
7
Mounting the fan-motor assembly
(standard mount)
WARNING: When using the standard ball/downrod
mounting, the tab in the ring at the bottom of the
mounting bracket must rest in the groove of the
hanger ball. Failure to properly seat the tab in the
groove could cause damage to the wiring.
NOTE: The magnet is pre-attached on the canopy bottom
cover for you to remove and install easily.
□
Align the locking slots of the canopy (C) with the two screws (CC)
and alignment post (JJ) in the mounting bracket (A).
□
Push up the canopy (C) and turn it clockwise until the alignment
post (JJ) engages to the round hole and the screws (CC) engage to
the key slots.
□
Firmly tighten the two mounting screws (CC).
□
Align the oval shape on the canopy (C) with canopy bottom cover
(JJ). Push up the canopy bottom cover (DD) until the screw (CC)
heads engage to the slots on the canopy bottom cover (DD) so that
the magnetic canopy bottom cover (DD) can be attached to the
bottom of the canopy (C) properly.
8
Installing the blades
□
Attach a blade (F) to the fan motor assembly (E) by inserting the
blade (F) into slots in the side of the fan motor assembly (E) and
aligning the three screws holes in the blade with the holes in the
center flywheel and secure with screws (BB).
□
Make sure all the screws are firmly tightened.
□
Repeat these steps for the remaining blades.
JJ
11
Please contact 1-800-986-3460 for further assistance.
K
A
CC
C
B
DD
D
E
E
F
BB
HOMEDEPOT.COM/HOMEDECORATORS