Debris Between Blades; Use Environment - Össur PRO-FLEX Manual De Instrucciones

DEBRIS BETWEEN BLADES

• Noise may occur if sand or debris are present between blades.
• The prosthetist should remove the Spectra Sock and foot cover from
the device, and use compressed air to remove sand or debris.
N.B.: The device should always be used with a foot cover and Spectra
Sock to minimize dust and dirt from entering between carbon blades.

USE ENVIRONMENT

• Environmental operating temperature: -15 °C (+5 °F) to 50 °C (122 °F).
• Operating humidity: 10-95% relative humidity
• Shipping and storage temperature: -20 °C (-4 °F) to 70 °C (158 °F).
LIABILITY
The manufacturer recommends using the device only under the specified
conditions and for the intended purposes. The device must be
maintained according to the instructions for use. The manufacturer is
not liable for damage caused by component combinations that were not
authorized by the manufacturer.
COMPLIANCE
This device has been tested according to ISO 10328 standard to two million
load cycles. Depending on the user's activity this corresponds to a duration
of use of two to three years. We recommend carrying out yearly safety
checks. This device has been tested for moderate impact level use. Refer to
ISO - "P" - "m"kg *)
*) Body mass limit not to be exceeded!
For speci c conditions and limitations of use see
manufacturer's written instructions on intended use!
body mass. In these cases, the test loads have been adapted adequately on
the basis of the specified load level.
Category
1
2
3
4
5
6
7
8
9
WARRANTY
Össur provides a warranty of 36 months for the device and 6 months for
the foot cover.
ISO 10328 - label
Weight (Kg)
52
59
68
77
88
100
116
130
147
category selection chart for low
and high impact level use. In the
standard mentioned, test levels
(P) are assigned to certain
maximal body masses (m). In
some cases, which are marked
with*), no test level is assigned to
the device related to maximal
Label text
ISO 10328–P3–52–kg
ISO 10328–P3–59–kg
ISO 10328–P3–68–kg
ISO 10328–P4–77–kg
ISO 10328–P4–88–kg
ISO 10328–P5–100–kg
ISO 10328–P6–116–kg
ISO 10328–P6–130–kg
ISO 10328–P6–147–kg
8