Horizon Global 41953 Instrucciones De Instalación página 3

Always wear SAFETY GLASSES when
installing hitch
Frame Rail
②
④
Fasteners
typical on
both sides
1. Install side brackets: Using a clamp, secure and align the side brackets with attachment holes on frame rails, see Figure 1. Using 24mm
socket, loosely install (6) M16 bolts ① and (6) M16 flange nuts ② to hold side bracket, both sides.
2. Install center section: Raise the center section into position and loosely secure with side bracket using (4) 9/16'' bolts ③, (4) flat washers ⑤
, and (4) locknuts ④, both sides.
3. Torque all 9/16" fasteners to 120 lb.ft. (163 N*M) and all M16 fasteners to 210 lb.ft. (285 N*M)
Proper torque is needed to keep the hitch secure to the vehicle when towing.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should
be removed and replaced. Observe safety precautions when working beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and SAE J684.
©2021 Horizon Global™ Corp - Printed in Mexico
Installation Instructions
PART NUMBERS: 41953, 96953, CQT41953
②
①
⑤ ③
①
Figure 1
②
①
③ ⑤
③ ⑤
①
Sheet 3 of 12
Fastener Kit: 41953F
① Qty. (12) Bolt
M16 X 2.00 X 50mm
Qty. (12) NUT
②
M16X2.00 CL10 FLG LK
Qty. (8) Bolt
③
9/16-18 X 1.75 GR5
④ Qty. (8) LOCKNUT
FLG 9/16-18 GRC
⑤ Qty. (8) WASHER
FLAT 9/16 HARDENED
②
④
41953NP 3-12-21 Rev. A