Disposal Information; Declaration Of Conformity; Exemption From Liability; Warning - Flex L 26-6 230 Instrucciones De Funcionamiento Originales

L 26-6 230
Operate the power tool via a residual-
current-operated circuit-breaker (tripping
current 30 mA).
Regularly clean the power tool and ventilation
slots. Frequency of cleaning is dependent on
the material and duration of use.
Regularly blow out the housing interior and
motor with dry compressed air.
Carbon brushes
The angle grinder features cut-off carbon
brushes.
When the wear limit of the cut-off carbon
brushes is reached, the angle grinder
switches off automatically.
NOTE
Use only original parts supplied by the
manufacturer for replacement purposes.
If non-original parts are used, the guarantee
obligations of the manufacturer will be
deemed null and void.
When the power tool is being used, the
carbon brushes can be seen sparking
through the rear air inlet apertures. If the
carbon brushes spark excessively, switch
off the angle grinder immediately. Take the
angle grinder to a customer service
workshop authorised by the manufacturer.
Gears
NOTE
Do not loosen the screws on the gear head
during the warranty period. Non-compliance
will deem the guarantee obligations of the
manufacturer null and void.
Repairs
Repairs may be carried out by an authorised
customer service centre only.
Spare parts and accessories
For other accessories, in particular grinding
tools, see the manufacturer's catalogues.
Exploded drawings and spare-part lists can
be found on our homepage:
www.flex-tools.com

Disposal information

WARNING!

Render redundant power tools unusable
by removing the power cord.
EU countries only
Do not throw electric power tools
into the household waste!
In accordance with the European Directive
2012/19/EU on Waste Electrical and
Electronic Equipment and transposition into
national law used electric power tools must
be collected separately and recycled in an
environmentally friendly manner.
NOTE
Please ask your dealer about disposal
options!

-Declaration of Conformity

We declare under our sole responsibility that
the product described under "Technical
specifications" conforms to the following
standards or normative documents:
EN 60745 in accordance with the
regulations of the directives
2014/30/EU, 2006/42/EC, 2011/65/EU.
Responsible for technical documents:
FLEX-Elektrowerkzeuge GmbH, R & D
Bahnhofstrasse 15, D-71711 Steinheim/Murr
Eckhard Rühle
Manager Research &
Development (R & D)
06.06.2016; FLEX-Elektrowerkzeuge GmbH
Bahnhofstrasse 15, D-71711 Steinheim/Murr

Exemption from liability

The manufacturer and his representative
are not liable for any damage and lost profit
due to interruption in business caused
by the product or by an unusable product.
The manufacturer and his representative are
not liable for any damage which was caused
by improper use of the product or by use of the
product with products from other
manufacturers.
Klaus Peter Weinper
Head of Quality
Department (QD)
23