Chattannoga OptiFlex SHOULDER CPM Modo De Empleo página 22

Follow these steps to program pauses:
• Access menu level 2, then press the
parameter key to select the special
function .
• The display indicates the symbol for
the special function and the selected
pause durations.
top: abduction/external rotation
pause
bottom: adduction/internal rotation
pause (see display image)
The pause duration for
abduction/external rotation appears
in a dotted frame.
• To change the abduction/external
rotation pause, press the "+" or "-"
key. Select a duration of 10 seconds,
for instance.
• Press the parameter key again
when done. The dotted frame
automatically moves to the line
below, indicating that the adduc-
tion/internal rotation pause can be
adjusted.
The parameter key is only used to
toggle between these two functions.
• To modify the value, press the "+"
(plus) or "-" (minus) key. Select a
duration of 5 seconds, for instance.
• Save the programmed values by
pressing the STOP key, then press
the START key to begin the treat-
ment.
■ Therapy timer
Default setting is continuous
operation.
A clock symbol in the upper right-
hand corner of the display identifies
the continuous mode of
operation.The clock indicates the
elapsed therapy time.
In the continuous mode, the device
must be stopped with the STOP key.
However, the therapy timer can be
set in steps of 1 minute to any
value between 1 and 300 minutes.
At the end of the therapy time, the
device automatically stops in the
starting position (maximum adduction
position / halfway between internal
and external rotation).
In this case, a circle replaces the
clock symbol. The circle fills as the
therapy time progresses.
■ Speed
The speed can be adjusted between
1 % and 100 % in steps of 1 %.
100 % is equivalent to 230°/minute
Default: 100 %
■ New patient
With this function, the CPM device
will move to the home position.
• Select the function and press the
START key:
– The carriage moves to the home
position.
– The programmed treatment
parameters are deleted.
– All values stored on the chip card
are deleted.
– The device stops halfway between
the abduction/adduction and
internal/external rotation position.
The "New patient" function (home
position) selects the following
settings:
22