Operation; Load And Unload The Table Only With A Forklift Or A Crane; Lift; Lower - BlitzRotary Hubtisch MGO Instrucciones De Uso

5.1

Load and unload the table only with a forklift or a crane

WARNING!
◼
Always use suitable retaining devices for the vehicle parts to be removed. Fix
them on the tabletop with bolts M10 (→10.4).
◼
Always distribute the load uniformly on the tabletop.
◼
Loads can not protrude beyond the tabletop.
Exception: Use of approved retaining devices
◼
◼
◼
◼
◼
◼
◼
◼
◼
5.2

Lift

◼
◼
◼
◼
5.3

Lower

◼
◼
5.4

Adjusting the inclination of the tabletop

The tabletop can be inclined in 2 directions by 3.5° each.
◼
◼
◼
◼
126932
Operate the roller brake [15].
Install the retaining device.
Retract the tabletop [8] completely.
Engage the safety catch [10] at the desired position.
Level the table with angle adjustment [12].
Fix the table position with the clamping support [7].
Use the lowering valve [1] to lower the lift table to the lowest position.
Lower the load with a forklift or a crane slowly onto the retaining device.
Secure the load with belts or straps.
Operate the roller brake [15].
Unfold the foot pump [2].
Use the foot pump [2] to adjust the table height.
Fold up the foot pump [2].
Operate the roller brake [15].
Use the lowering valve [1] to lower the lift table to the lowest position.
WARNING!
Observe the load when inclining the tabletop.
Stop the process immediately in case of doubt.
First, loosen the table fixation, so that the supports automatically can follow the
tabletop during inclination.
Then fix the setting with the clamping support.
Operate the roller brake [15].
Loosen the clamping support [7] for the tabletop.
Adjust the inclination of the tabletop with angle setting [12].
Fix the table position with the clamping support [7].
Lift Table MGO

Operation

59