Transporting A Load; Use As Work Table; Sliding Panel; Installation And Removal Of Parts With The Table At The Lifted Vehicle - BlitzRotary Hubtisch MGO Instrucciones De Uso

Lift Table MGO
Operation
5.5

Transporting a Load

◼
◼
◼
◼
◼
◼
5.6

Use as Work Table

◼
◼
◼
◼
◼
◼
5.7

Sliding panel

For separation of engine and transmission, the table has a fixed and an extendible tabletop.
Therefore, the engine must be placed on the fixed tabletop and the transmission on the extendible
tabletop.
◼
◼
5.8

Installation and removal of parts with the table at the lifted vehicle

5.9

End of Work

◼
◼
◼
60
WARNING! Danger of crushing
Always drive slowly.
The driveway must be free of obstacles.
Always use two persons when transporting heavy loads.
Fold up the foot pump [2].
Install the sliding handle [4].
Secure the sliding handle [3] with a splint.
Operate the lowering valve [1] and lower the lift table to the lowest position.
Loosen the roller brake [15].
Drive the load to the desired location.
Operate the roller brake [15].
Use the foot pump [2] to adjust the table height.
Adjust the table with angle adjustment [12] to level condition.
Fix the table position with the clamping support [7].
Fold up the foot pump [2].
Remove the sliding handle [4] if required.
Always pull out the tabletop [8]
until the safety catch [10] engages.
Secure the position with the clamping screw
[11]. (Refer to Fig. 2)
WARNING!
Before work under the lift, the lift shall be secured against restart
When installing or removing vehicle parts, use only the lift table for lifting and
lowering movement.
Never leave the lift table unattended under a lifted vehicle.
Use the lowering valve [1] to lower the lift table to the lowest position.
Park the lift table at a suitable location.
Operate the roller brake [15].
Fig. 2
126932