First Start-Up - Saci pumps VSD Magnus Manual De Instalación Y Mantenimiento

8 FIRST START-UP

N.B.: It is important to know that, if there is a set of pumps connected together, only one of the pumps should
be programmed, as all of the information entered is automatically copied to the other pumps that make
up the network. The only action that must be performed on the rest of the pumps is to select the rotation
direction, since it is the only data that is particular to each pump.
The first time you apply voltage to your unit, you will see parameter 1.1 that belongs to menu 1 General
Setup, which at the same time is the start-up wizard.
You will also see this screen if you restore the factory settings.
In this menu, enter the basic parameters of the installation prior to programming the time intervals that you
wish to have the pump filtering.
1 . 1
Select the desired language with the ( ) key and, with the F2 key (Next), move on to parameter 1.2 to
continue with the set-up wizard.
T u e s d a y
In this parameter enter the date and time. The speed variator will be governed by this for scheduling the start
and stop times. Continue with F2 key to access the screen where you will enter the nominal current of the
motor, indicated on its specifications plate. At this point it is advisable to indicate that the current established
will be taken as the nominal for all the motors that are part of the filtration system. For this reason it is
imperative that all the pumps are the same model; if they are not, the pumps with a lower electricity demand
will not be protected by the energy consumption monitoring.
1 . 3
B a c k
With the keys ( ) and ( ) you can increase and decrease, respectively, the nominal consumption of the
pump motor. Use the F2 key to move on to menu 1.4.
1 . 4
B a c k
VSD Magnus - [e]Magnus
26
L E N G U A G E
E n g l i s h
C O N F I G U R E
D A T E A N D
2 7 / 0 6 / 1 7
M O T O R
C U R R E N T
5 . 0
N O . O F
P E R
1
N e x t
T I M E
- 1 0 : 2 0
N e x t
A m p
N e x t
P U M P S
C I C L E
N e x t