JOLLYNOX 1PVG2 - 01 Instrucciones Y Sugerencias Para El Uso, La Instalación Y El Mantenimiento página 25

IMPORTANT:
always disconnect the appliance from the gas
and electricity mains before carrying out any
cleaning operation.
3) HOT PLATE
Periodically wash the hot plate, the enamelled stell
pan support, the enamelled burner caps "C" and
the burner heads "T" (see fig. 8) with lukewarm
soapy water. Following this, all parts should be
thoroughly rinsed and dried. Never wash them
while they are still warm and never use abrasive
powders. Do not allow vinegar, coffee, milk, salted
water, lemon or tomato juice from remaining in
contact with the enamelled surfaces for long
periods of time.
CLEANING
Note: continuous use could cause the
burners to change colour due to the high
temperature.
WARNINGS:
comply with the following instructions, before
remounting the parts:
- check that burner head slots "T" (fig. 8) have
not become clogged by foreign bodies.
- Check that enamelled burner cap "C" (fig. 8)
have correctly positioned on the burner head.
It must be steady.
- The exact position of the pan support is
established by the rounded corners, which
should be set towards the side edge of the
hot plate.
- Do not force the taps if they are difficult open
or close. Contact the technical assistance
service for repairs.
- Correctly preserve the plate after use by
treating it with special products, easily
available on the market. This will keep the
surface of the plate clean and bright. The
operation will also prevent the formation of
rust.
- Don't use steam jets for the equipment
cleaning.
- Burned food on an electric plate must be
removed dry.
- After use, pour a little lukewarm oil on the
plate and wipe it with a cloth.
FIG. 8
25