Italpunte S65 Manual De Empleo Y Manutención página 25

The breaker is in accordance with CE regulations about noise 2000/14. Nevertheless it's recommended to
use anti-noise cap, both for the operator and the workers in the surrounding. It's obligatory to wear helmet
GB
and plastic glasses for the workers in the surrounding.
To reduce the risk of serious injury or death to themselves or others, it is essential to carefully read and
understand the safety instructions and operating instructions before installing, operating, repairing the
hammer, and carry out maintenance or change of accessories same. It 'also important to make visible these
safety instructions and use in workplaces, provide copies to employees and make sure everyone reads before
use or maintenance of the hammer. The use and maintenance of the machine are exclusively reserved to
trained and qualified personnel properly: it must be able to physically handle the bulk, weight and power of
the tool.
The Transport
The transport of hydraulic breaker can only be performed by personnel :
- Authorized to operate a crane or a forklift in accordance with the applicable national directives
- Aware of the safety instructions and the instructions for national accident prevention
- It has read and understood the chapter on safety and the carriage contained in this manual.
- The fall of the breaker can cause injury
- Place the hydraulic breaker in a safe position, so that it cannot fall and cause damage.
- In order to lift it safely, adjust the lifting hook as shown in the image on the hammer
Installation, maintenance and storage
The installation , storage, maintenance of hydraulic breaker can only be performed by personnel :
- Aware of the safety instructions and the instructions for national accident prevention
- It has read and understood the safety instructions and operating instructions .
Functioning
The functioning of the hydraulic breaker can only be performed by qualified operators of transport carriers .
The operators of transport carriers are qualified if :
- They have been trained to operate half carrier in accordance with national guidelines ;
- They are aware of the safety instructions and the instructions for national accident prevention
- They have read and understood the safety instructions and operating instructions .
Testing
The testing of the hydraulic system should be performed only by qualified and authorized to approve such a
system in accordance with the rules in force
Personal Protection Equipment
Always use approved protective equipment. Operators and all other persons in the work area must wear
protective equipment, which will include at least:
- Helmet
- Hearing protection
- Impact-resistant safety goggles with side shields
- Respiratory protection, if necessary
- Protective gloves
- Protective footwear appropriate
.
24