Troubleshooting - SHUR-DRI SD-108 Manual De Instalación

Troubleshooting / Repair Parts

TROUBLESHOOTING

SYMPTOM
Pump will not prime
Pump will not pump
11
10
9
8
7
4B
3
2
1
For parts or assistance, call Shur-Dri Customer Service at
PROBABLE CAUSE(S)
There are leaks in the
suction line
Water being pumped is more
than 10 feet below the pump
Pump was not properly primed
14B
14A
13
12
6
5
4A
3789 1000 GEN
CORRECTIVE ACTION
Be certain all connections are air tight. Test the connections
by putting soap suds on them. If there is a leak, the soap
suds will be sucked into the loose fittings.
Move the pump closer to the water being pumped.
Refer to the steps for priming the pump, included in the
"Installation" section, on Page 3.
REPAIR PARTS LIST
Key
No. Description
1 Screw, Cover
2 Cover Plate
3 O-Ring
4A Outer Wearplate
4B Inner Wearplate
5 Impeller
6 Cam Ring
15
7 Seal, U-Cup
8 Washer
9 Housing Body
10 Screw
11 Water Slinger
12 Motor
13 Cord Set
14A Fuse Holder
14B Fuse
15 Pud-L-Scoop
• Not illustrated.
* If the motor fails, replace the pump.
Part
Qty.
4 670-656
1 230-298
1 546-023
1 721-122
1 721-122
1 416-011
1 134-007
1 16FA019-4
1 854-341
1 404-114-B
2 670-657
1 RP0001616
1 *
1 992-695
1 U17-1148
1 344-001
®
1 992-653
1-800-535-4950
5
SD-108