TOUGHBUILT TB-H2-LL-100-L2 Instrucciones De Funcionamiento página 11

Out of the box, the very first thing you must do is verify calibration of the tool. A laser
level which is not calibrated and level itself is of no use. Thereafter, to safeguard your
investment and work, you should always verify the calibration, as outlined below:
CAUTION! ANYTIME the tool is to be moved, MAKE SURE that the pendulum is in its
LOCKED position.
CAUTION! When moving the tool from a warm environment into a cool environment,
moisture may accumulate on the laser output lenses 1 and 2. Allow the tool to stabilize to
the new environment first. DO NOT turn on a wet or damp tool. To wipe the Laser Reflector,
use ONLY a lint-free cloth. DO NOT USE A PAPER TOWEL.
Before replacing the batteries, make sure that the Pendulum is in the LOCKED position,
and the power is turned off.
DANGER
LASER IN OPERATION
TRAINED
PERSONNEL ONLY
remaining two batteries. While holding the end of the band down, insert the lid-alignment
pins into the compartment edge and close the lid. Make sure the latch snaps in place,
indicating that the lid is secured.
Position and secure the Cross Laser on a leveled pedestal, Ceiling Bracket
D , or a tripod (DO NOT overtighten the mounting screw).
Bracket
WARNING! DO NOT position the tool at eye level.
With the Pendulum Switch
laser. Elevated the horizontal beam to the deired height. Slide the Pendulum Switch
the UNLOCK position. The laser beam will be activated and may fluctuate at first. Allow
time for the self-leveling system to stabilize within its operating tolerance of ±3.5°
degrees. Should the laser beam keep fluctuating, it is an indication that the tool is tilted
beyond its seld-leveling limits. It may also be an indication of low battery power.
To open the battery cover, push the battery compartment latch
and lift the cover slightly. Pull the lid away from the compartment
until the two securing pins on the lid are clear of the case. The
positive pole of each battery should face in the same direction,
toward the topside of the compartment (see + markings in the
compartment). Insert the first battery in the center well over
the removal band. Fold the band over the battery and insert the
3 in the Locked position, push the ON button to activate the
8
C
, Mounting
4 to
11