Set-Up And Assembly - TOUGHBUILT TB-H2-LL-100-L2 Instrucciones De Funcionamiento

To set up the tool:
• Inspect the box for damage.
• Remove the contents of the box and lay everything on a flat, clean and dry surface.
Check the contents against the packaging list, and familiarize yourself with their names.
• Write the requested information on the Registration Form found at the end of the
manual. Keep this information at a safe location. When contacting
ToughBuilt Industries, Inc. for assistance or for possible warranty claims,
®
the information on the registration form will be required.
• Keep the box for storing the tool.
• Read, study and familiarize yourself with all aspects of this manual before attempting
to power the tool on.
• The work area should be clear of obstructions.
• Floor surface where the Cross Line Laser is to be placed should be hard, level and stable.
• A tripod, a pole or any other tool onto which this Cross Laser would mounted should
be able to support the tool's weight safely.
• When using a tripod, the legs should be placed on a hard/solid surface to prevent
shifting or sinking. Make sure to extend and lock all legs, and secure the tool to the
mounting hardware. DO NOT over-tighten the mounting screw.
DO NOT USE IF DAMAGED.
•
ALWAYS STAY ALERT AND USE COMMON SENSE. Follow all safety warnings and
•
precautions in the manual as well as those on the product.
AVOID distractions.
•
Before turning the tool on, ALWAYS familiarize yourself with the controls and their
•
functions before use.
DO NOT open or dismantle the tool, or attempt to make modifications to the tool.
•
Personal and property damage may occur.
DO NOT force any component to do a job. If it does not move, there might be a reason.
•

SET-UP AND ASSEMBLY

4.
9