Assembly And Installation - LIVARNO home 1033-S Instrucciones De Uso Y De Seguridad

z Assembly and installation
DANGER OF OVERHEATING! Do
not operate the product while it is
still inside the packaging!
NB: Take the product out of its packaging
and remove all packing material.
Check that all package contents are
„
present.
Check if the product or individual parts are
„
damaged. If that is the case, do not use the
product. Contact the distributor via the
service address given in the warranty
section.
DANGER OF INJURY!
If the product is not secured
properly it may tip over and cause
injury.
Do not place the product on a surface that
„
is not flat.
Make sure that the ground sufficiently flat
„
when using the ground spike.
Make sure that the ground spike is also
„
removed when taking out the product so
that there is no risk of tripping.
LED star (1033-S) with stand
RISK OF DAMAGE! Before setting
up the product on the pedestal,
protect sensitive surfaces.
Place the LED star
„
attach the two together firmly using the
hand screws (see Fig. A).
3
Place the product on a flat surface. Make
„
sure that the stand is stable.
NB: Make sure that the hand screws
firmly attached.
LED star (1033-S) with ground spikes
Attach the individual ground spikes
„
the LED star and fix in place by
1
fastening the screws
hand (see Fig. B).
on the stand and
1 2
are
3
to
4
on the spike by
3
NB: Ensure the ground spikes are facing the
right direction (angle of the openings) as
shown in Fig. B.
Insert the product into the surface, e.g.
„
lawn/soil etc.
NB: Make sure the product is firmly
attached. Do not use force, e.g. a hammer,
during assembly or installation. This could
damage the product.
Setting up the LED tree (1033-T) with
stand
RISK OF DAMAGE! Before setting
up the product on the pedestal,
protect sensitive surfaces.
Using the two screws
„
underneath the LED tree
12
E).
Place the product on a flat surface. Make
„
sure that the stand is stable.
Setting up the LED tree (1033-T) with
ground spike
Using the two screws
„
spike underneath the LED tree
14
Fig. F).
Insert the product into the surface, e.g.
„
lawn/soil etc.
NB: Make sure the product is firmly
attached. Do not use force, e.g. a hammer,
during assembly or installation. This could
damage the product.
Connect power supply
RISK OF ELECTRIC SHOCK!
Plug the connector
„
the mains plug
8
Tighten the union cap
„
thread of the connection socket
Plug the mains plug
„
has been correctly installed.
, fasten the stand
13
(see Fig.
11
, fasten the ground
13
(see
11
into the socket
5 7
(see Fig. C).
on the screw
6
�
7
into a socket that
8
GB/IE/NI/CY/MT
of
45