Two-Cup Function; Using Steam - Krups ESPRESSERIA AUTOMATIC Manual Del Usuario

All manuals and user guides at all-guides.com
FALC DISP USA - 7220.qxp
When the machine is plugged in, an inintializing cycle is processed. Press the on/off button
and perform a rinsing operation if you wish.
The selection menu will
be displayed.
To stop coffee from flowing into the cup, you can either press "OK" again or turn the rotating button to reduce volume.
Please note : The ground coffee is first moistened with a little hot water after the grinding stage. This is called
"pre-brewing" and it optimizes the brewing process by ensuring that the grounds are evenly wet.
A few moments later, the full brewing cycle begins.
DO NOT REMOVE THE WATER TANK BEFORE THE END OF THE CYCLE (i.e. 15 sec. after coffee stops flowing).
There is a temperature setting function to control how hot your coffee is (see Settings).
You can use your machine to make 2 cups of coffee or espresso for the 3 following recipes: espresso / strong espresso / cof-
fee by cycling the machine twice. Remember not to remove the cups after the first cycle.
Put two cups under the
coffee outlets.
You can lower or raise the
coffee outlets to suit the
size of your cups.
Steam is used to froth milk (for cappuccino/latte) but can also be used to reheat other liquids. As you need a higher tempera-
ture to produce steam than to make an espresso, the machine runs an additional pre-heating phase for steam.
When the screen displays the selection menu, press the "steam" key
inform you that the machine is being pre-heated. Once the pre-heating phase has been
completed, a message will ask you to place a container under the steam nozzle. Press the
"steam" key
then steam will start. Use the same key to stop steam generation.
CAUTION, STEAM CYCLE DOES NOT STOP IMMEDIATELY
4/12/07 18:49 Page 9
Put a cup under the coffee Use the rotating button
outlets.
to select your choice
You can lower or raise the and confirm by pressing
coffee outlets to suit the the OK button.
size of your cups.

TWO-CUP FUNCTION

x 2
Select your drink and
confirm by pressing the
OK button twice. A mes-
sage will appear to tell
you that you have
chosen two cups.

USING STEAM

again to start generating steam. A little water will be produced first and
9
, wait for the end of pre-heating
You can change the
volume of water at any
time using the rotating
knob.
The machine will
automatically
sequence through
two complete cycles.
. The screen will