Wireless Information - Siemens HS Manual Del Usuario

must accept any interference, including interference that may cause
undesired operation of the device.
The above applies to CIELO® 2, ARTIS® 2, ACURIS®, CENTRA®, and
Motion 701, 501, 301. All other remote control compatible custom
hearing instruments use e2e wireless 2.0.
Technical information for e2e 2.0 wireless function:
FCC: SGI-WL002ITE IC: 267AB-WL002
Operating frequency : Fc = 3.28 MHz; Maxium field strength: –7 dB
µA/m at 10m meters.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Wireless Information

The following table summarizes the technical details of the wireless
technology:
Antenna Type
Antenna Dimensions
Modulation
Magnetic Field Strength
(at 10 m distance)
Output Power (EIRP**)
20
Wireless Hearing Aids
Inductive Antenna
Ø1.9 mm, L – 6.5 mm
PSK (Phase Shift Key)
0.09 A/m (1 cm2 coil; average)
42 µW