Push Button On/Off; Power On Delay; Low Battery Indicator; Volume Control Alert Tones - Siemens HS Manual Del Usuario

• A built-in pairing table which specifies valid and legitimate
pairing among units.
• A proprietary Siemens communication protocol which checks
the package numbers during each transmission.
• A Cyclic Redundancy Check (CRC) to check data validity and
correct errors.

Push Button on/off

Your Siemens hearing instruments may be programmed to allow you to
turn them on and off using the program button. To turn the instrument
off using the program button, press and hold the button for 3–5
seconds. To turn it back on, press and hold the program button for 3–5
seconds. Please note that after having turned the hearing instrument off
using the program button, you must wait approximately 10 seconds for
the system to reset before turning it back on again by using the program
button.

Power on delay

Your hearing instruments may be equipped with an advanced power
on delay feature. This feature delays sound from entering your hearing
instruments when they are first turned on so that you may insert the
instruments into your ears without experiencing unpleasant feedback
(whistling).

Low battery indicator

Your hearing instrument may be programmed to inform you when
the battery should be replaced for best performance. You may hear an
intermittent series of beeps and/or experience low amplification power
or volume. Change the battery immediately if either of these should
occur.

Volume control alert tones

Your hearing instrument may be programmed to inform you of changes
to volume. You may hear soft beeps each time you change the volume
and a three beep warning when the volume limit has been reached.
Once the maximum or minimum volume has been reached, further
changes in that direction will have no effect.
22