Water Supply And Drain Connections - Hoshizaki DIM-30AE Manual De Instrucciones

5. WATER SUPPLY AND DRAIN
CONNECTIONS
WARNING
Connect to potable water supply only.
* The connections to the mains water supply
must be made in accordance with the countries'
current requirements of the Water Supply or
Water Fittings Regulations.
* I c e m a k i n g w a t e r m u s t b e p o t a b l e w a t e r.
Where scaling can be caused by water quality,
installation of an external filter or softener
is recommended. Contact your local water
treatment professional or Hoshizaki service
agent.
* Water supply pressure should be minimum 0.05
MPa (0.5 bar) and maximum 0.8 MPa (8 bar).
If the pressure exceeds 0.8 MPa (8 bar), use a
proper pressure reducing valve. Do NOT throttle
back the supply tap.
* A plumbing permit and services of a licensed
plumber may be required in some areas.
* The water supply and drain pipes should not
block the air ventilation slots on the rear panel.
* The ice dispenser drain is gravity flow, so ensure
drain pipe has an adequate pitch or fall.
* Water should drain into an open trap.
* Leave a vertical air gap of at least twice the drain
pipe diameter between the end of the drain pipe
and the top of the open trap.
* Be sure to use the new hose-sets supplied with
the appliance. Do not reuse any old hose-sets.
1) By means of a suitable spanner or wrench,
tighten the 1/2-3/4 nipple (accessory) into the
Rc1/2 fitting on the rear of the ice dispenser as
indicated. P.T.F.E. tape and/or a suitable sealing
compound should be used to obtain a leak free
joint.
Note: Jointing compounds should be approved
and suitable for potable water use.
2) Attach angled end of white flexible inlet hose
(accessory) to free end of 1/2-3/4 nipple
ensuring rubber sealing washer is correctly
positioned. Hand tighten sufficiently to provide
leak free joint.
3) Attach the other end of inlet hose to the water
tap, noting washer is correctly positioned before
hand tightening as above.
4) Attach grey flexible outlet hose (accessory) to
the R3/4 fitting as indicated, confirming fitment of
rubber washer before finally hand tightening the
joint. This pipe can be cut to length as necessary
to suit position of main drain.
Inlet Hose
Outlet Hose
II. OPERATING INSTRUCTIONS
WARNING
1. This ice dispenser is designed to produce
and store edible ice. To keep the ice
dispenser hygienic:
* Keep the ice station clean. Clean it
by using a neutral cleaner and rinse
thoroughly.
3
ENGLISH
Water Supply Inlet
Rc1/2
1/2-3/4 Nipple
Drain Outlet R3/4
Fig. 3
Water Supply Tap
Inlet Hose
Fig. 4