Safe Operating Condition; Prevention Of Hazards; Mechanical Hazards; Electrical Hazards - Zeiss Primostar 1 Manual De Instrucciones

ZEISS
Special application training is offered for a fee. Current training dates, additional information and
the registration form can be found at
ing-and-education.html.

2.2.2 Safe Operating Condition

If circumstances occur which impair safety and cause changes in operating behavior, the Micro-
scope must be shut down immediately and a ZEISS service representative should be informed. The
Microscope can only be operated after proper installation by a ZEISS service representative and in
compliance with the operating conditions. The Microscope may only be operated after correct in-
stallation by a ZEISS service representative and if the operating conditions are adhered to.
§
§
§

2.3 Prevention of Hazards

This section summarizes potential hazards and recommended safety precautions. Failure to follow
the safety instructions and instructions may result in personal injury and property damage.

2.3.1 Mechanical Hazards

Property Damage There is a risk of injury and property damage if the Microscope is improperly handled and trans-
due to Transport ported.
§

2.3.2 Electrical Hazards

Voltage Hazards Risk of electric shock in case of contact with live parts.
Always use the power adapter supplied by ZEISS. When an unsuitable power adapter is used,
ZEISS can no longer guarantee the electrical safety and functionality of the Microscope.
§
§
§

2.3.3 Hazards Generated with the Operating Environment

Dirt, Dust and Dirt, dust and moisture can impair the Microscope's functionality.
Moisture
§
§
§
§
§
§
Instruction Manual ZEISS Primostar 1 | en-US | Rev. 2 | 415501-7021-111
Do not operate the Microscope until you have completely read and understood the entire
documentation delivered with the Microscope.
Make sure that all protective cover panels are installed and all warning labels are available and
legible.
Ensure conditions and take measures to prevent the build up of electrostatic charge on the
workplace.
Only use the handle, if applicable, for transport of the Microscope. Otherwise hold the Micro-
scope with one hand and the base plate with the other hand.
Shut down the Microscope.
Disconnect the power supply before cleaning.
Set up and operate the Microscope so that the connectors are easily accessible.
Shut down the Microscope whenever it is not used and cover it with a dust protection cover.
Always cover unused openings/ports.
Regular maintenance and cleaning according to the instructions in this document.
Make sure that no cleaning liquid or moisture gets inside the Microscope.
Make sure that the electrical parts never come into contact with moisture.
Never expose the Microscope to inadmissible climate conditions (high humidity and tempera-
ture).
https://www.zeiss.com/microscopy/int/service-support/train-
2 Safety | 2.3 Prevention of Hazards
9