Troubleshooting Chart - EMAK Oleo-Mac Gi 44 Manual De Uso Y Mantenimiento

WARNING: always stop the machine and disconnect the safety connector before carrying out the corrective
checks recommended in the table below, except when they require the machine to be in operation.
When you have checked all the possible causes listed and you are still experiencing the problem, see your Servicing Dealer. If
you are experiencing a problem that is not listed in this chart, see your Servicing Dealer for service.
PROBLEM
Engine will not start or will run only
a few seconds after starting.
Engine starts and runs, but blade is
not rotating
WARNING: Never touch the
blade while the engine is
running.
WARNING! Also read the battery and battery charger instruction and maintenance manual!

13. TROUBLESHOOTING CHART

POSSIBLE CAUSE
Battery drained or fitted incorrectly
1.
Power cable damaged.
2.
Motor protector triggered due to
3.
engine overheating.
Safety plug not inserted
4.
Starting lever microswitch damaged
5.
Damaged battery
6.
Autogoods "130"
SOLUTION
Charge the battery or fit it correctly
1.
Have the cable replaced by an Authorised
2.
Service Centre.
3. Wait several minutes before restarting the
machine.
Check and/or insert
4.
Contact an Authorized Service Centre
5.
Contact an Authorized Service Centre
6.
Switch off the motor immediately and contact
an Authorised Service Centre.
GB
23