Seat Adjustment - Cub Cadet SurePath Pro Z Serie Manual Del Operador

7. Remove the seat tilt knob assembly
from the bag and install as shown
in Figure 2-12.
(h)
(a)
(e)
Figure 2-12
NOTE: Be sure to orient the recliner
plate (a) and install the plastic
washer (b), spring washer (c) and
metal washer (d) as shown in
Figure 2-12. The plastic washer is on
the inside.
8. Slide the recliner bearing plate (a)
onto the recliner pin (e). Refer to
Figure 2-12.
9. Then align the spiral (a) on the
inside of the recliner knob with the
recliner pin. Make sure the hub on
the back of the recliner sits properly
into the large holes of the side
plate. See Figure 2-13.
(a)
Figure 2-13
10. Use a wrench to hand tighten the
hex screw (g) until the recliner
knob (f) is difficult to turn. Refer to
Figure 2-12.
NOTE: Do not use power tools
to install.
11. Gradually loosen the hex screw (g)
until the recliner knob moves freely.
Do not loosen the hex screw (g)
more than one full turn. Refer to
Figure 2-12.
10 S 2 — A
ection SSembly
12. Securely install the 1/4" nut onto
the clinch-stud (h) and rotate
the recliner knob to check the
operation of the seat. Refer to
Figure 2-12.

Seat Adjustment

(f)
Proper steering column and seat
adjustment will result in the following (to
(b)
adjust the seat see below):
(d)
In the neutral position with hands on the
(c)
steering wheel,
(g)
• Operator's upper arms should be
relaxed and approximately vertical.
• Operator's forearms should be
approximately horizontal.
• Operator's back should stay in
contact with the seat back.
• Steering column should not contact
operator's legs.
Check the results of any adjustments to
the conditions described above. Repeat
any adjustment procedures as required
until all conditions are met.
This machine is equipped with an
adjustable seat, which includes a
retractable seat belt assembly and an
Operator Presence Sensor (OPS). The
OPS, in the form of a switch, is integrated
into the seat bottom and is connected
to the machine electrical system. The
OPS must be connected to the electrical
wiring harness.
The seat can be adjusted forward and
backward, the armrests can be adjusted
up and down, and air ride adjustment,
a lumbar support, can be adjusted. The
seat can also tilt forward and backward.
NOTE: The seat base must be secured by
the latch, otherwise, the seat assembly
could tilt forward.
& S -U
et p
Seat Position
To move the seat forward or back, locate
the seat adjustment rod (a) under the
seat. Push the rod to the left, slide the
seat forward or back into the desired
position and release the rod when
the seat is in the desired position. See
Figure 2-14.
(a)
Figure 2-14
Seat Tilt
The seat tilt is controlled by the knob
on the left of the seat. Turn the knob
rearward to tilt the seat back, turn the
knob forward to tilt the seat forward. See
Figure 2-15.
Figure 2-15
Seat Lumbar
To vary the lumbar support move the
lever on the right of the seat up and
down. See Figure 2-16.
Figure 2-16