Cub Cadet SurePath Pro Z Serie Manual Del Operador página 9

3. Rotate both locking pins into the
LOCKED position. Move the upper
ROPS slightly until the locking
pins are fully engaged in the
LOCKED position.
Steering Wheel Column
The steering wheel column is tilted all
the way down for shipping purposes. To
adjust the column pull up on the steering
column adjustment lever (a) and move
the steering column up into the desired
position. Release the steering column
adjustment lever (a) to secure the
steering column in the desired position.
See Figure 2-5.
Figure 2-5
Steering Wheel
IMPORTANT! Do not use impact tools
to install or remove the steering wheel.
Doing so may cause damage to critical
power steering components.
1. Remove the hardware for attaching
the steering wheel from beneath
the steering wheel cap (a). Carefully
pry off the steering wheel cap
(a) to remove the hardware. See
Figure 2-6.
2. With the wheels of the machine
pointing straight forward, place the
steering wheel (b) over the steering
shaft. See Figure 2-6.
3. Place the Belleville washer (c) over
the steering wheel (b) and secure
with the hex lock screw (d). See
Figure 2-6.
4. Place the steering wheel cover over
the center of the steering wheel
and push downward until it "clicks"
into place.
Operator's Seat
1. Remove the two flange lock nuts
(b) and shoulder bolts (a) from the
manual bag. See Figure 2-7.
(a)
(a)
2. Place the seat into position and
secure the seat into place with the
hardware as shown in Figure 2-7.
3. Remove the shoulder screw (a) and
flange lock nut (b) from manual bag
and install the seat lockout bracket
(c) as shown in Figure 2-8.
(b)
(c) (d)
(a)
Figure 2-6
(a)
(b)
(b)
Figure 2-7
(b)
(a)
(c)
Figure 2-8
4. Insert the wiring harness (a) into
the bottom of the seat as shown in
Figure 2-9.
(a)
Figure 2-9
NOTE: When the wiring harness (a)
is connected, be sure to push the
excess wire from the wire harness
(a) into the seat box hole before
continuing. See Figure 2-9.
5. Remove the screw (a) securing
the recliner plate in the seat back
position. See Figure 2-10.
Figure 2-10
6. Tilt the seat forward into the full
forward position. Replace the
recliner plate with the clinch-stud
(a) and the recliner pin (b) passing
through the recliner plate in the
locations shown in Figure 2-11.
(a)
(b)
Figure 2-11
S 2 — A & S
ection SSembly et
(a)
(a)
-U 9
p