Mr Coffee frappe ICED + HOT Manual Del Usuario página 6

Tabla de contenido

Publicidad

LET'S MAKE ICED COFFEE!
1. Plug the coffeemaker in. Press power button. It will blink slowly in standby
for brew or blend.
2. Fill the tumbler
to the "WATER" marking with clean, filtered water.
17
3. Lift the lid
of the unit and pour the water into the reservoir.
7
4. Place the reusable coffee filter
filter) into the brew basket.
10
5. Using the ICED side of the coffee scoop
the reusable coffee filter
. Close the lid. Note: if you want a bolder cup of
9
iced coffee, you can use 1 ½ - 2 scoops of grounds.
6. Fill the tumbler
with large ice cubes to the "ICE" marking.
17
7. Place tumbler full of ice under drip spout
button – ensure the LED is illuminated.
8. Wait 3-4 minutes for brewing to complete. Once dripping slows and stops,
grab tumbler from underneath the spout.
drips may come from the drip spout post brew – the drip tray
these and keep your countertop mess free.
9. Add in your favorite coffee mix-ins for coffee just how you like it.
10. Insert the straw
in lid,
place on tumbler
19
18
NOTE: Immediately after brewing, the heater thermostat needs to cool down
to be ready for the next brew. Button indicator light may flash when pressing
"HOT BREW" or "OVER ICE;" wait a few more seconds for heater to cool off
before pressing again.
9.
6
(or standard 5-cup basket-style paper
9
, pour 1 scoop of grounds into
16
and press the "OVER ICE"
5
Note: a few sparse coffee
5
will catch
1
and enjoy!
17
LET'S MAKE HOT COFFEE!
1. Plug the coffeemaker in. Press power button. It will blink slowly in standby
for brew or blend.
2. Grab desired coffee cup or mug and fill with as much water as you would
like coffee.
Tip: Taller coffee mugs work best to avoid any splashing during brewing.
3. Pour water into the reservoir
. Observe how much water your poured on
6
the water ladder. Note: do not pour above 16 oz. max fill line as water
reservoir will overflow.
4. Place reusable coffee filter
in brew basket
9
5. Using the HOT side of the coffee scoop
correspond to amount of water poured.
HOT BREW
Water
Scoop
8 oz
12 oz
1 ½
16 oz
6. Pour coffee grounds into reusable coffee filter
Tip: ensure grounds to not spill into water reservoir when filling coffee
filter. Removing coffee filter to fill with grounds can help prevent accidental
spills into the reservoir
.
6
7.
Close the lid
. Note: if you prefer bolder hot coffee, you can use an extra
7
½ - 1 scoops of coffee grounds.
8. Place the mug that was used to measure water under the drip spout
Press "HOT BREW" button
.
4
9. Add in your favorite coffee mix-ins for coffee just how you like it. Enjoy!
.
10
, measure coffee grounds that
16
1
2
.
9
.
5
10.

Publicidad

Tabla de contenido
loading

Tabla de contenido