EN
Safety devices
Rollbar
[B] and seat belt
WARNING!
Risk of falling
Never use the device without the rollbar.
Do not operate the device with the rollbar
folded down.
Always wear a seat belt when the rollbar
is folded up.
The rollbar must always be locked in
a folded up, vertical position with the
bolts and safety splints designed for this
purpose, and secured.
Do not fasten the seat belt when the
rollbar is folded down.
In the case of damage or an accident,
have the rollbar and seat belt checked
in a specialist garage, and replace if
necessary. Do not undertake any repairs
on your own!
The device is equipped with a rollbar and seat belt.
Together, they represent optimal protection for the
driver.
Discharge flap
[A]
CAUTION!
Contact with the cutting blade and items
Risk of injury
Only operate the device with a discharge
Safety locking system
The safety locking system will only allow the engine
to start when
- The driver is sitting on the seat.
- the cutter deck has been switched off; i.e.: PTO
switch set to "O/Aus/Off" (PTO = Power-Take-Off).
- both drive control levers are in the outer neutral
recesses. Note: At the same time the parking
brake is activated in this position (park position).
14
The safety locking system automatically switches
the engine off as soon as the operator leaves
the seat with the cutter deck activated (PTO),
irrespective of whether the parking brake was
actuated beforehand.
The safety locking system automatically switches
the engine off as soon as the operator leaves the
seat without actuating the parking brake beforehand.
Note
The parking brake is activated if both drive
control levers are in the outer neutral re-
cesses.
Directional references
Directional references on the device (e.g. left, right,
etc.) always refer to when facing forwards.
Assembly
Note
To be able to move the device manually, the
gear release lever must be in the appropri-
ate position. Refer to the section "Operation
– Pushing the mower".
Setting up the rollbar
The rollbar is folded down for transport.
Remove the splint from the securing pins
Remove the securing pins
Fold out the rollbar fully
Insert the securing pins through the holes
Secure the bolts with the splints
Installing the drive control levers
Release the clamping screw on the right-hand
drive lever
.
Align the drive control lever
Tighten the clamping screw
control lever in this position.
Repeat these installation steps for the left drive
control lever.
Note
Both drive control levers should be installed
in the same vertical position.
Safety devices
.
.
.
.
.
so that it is vertical.
to lock the drive
769-12264