Starting The Engine; Stopping The Engine - Cub Cadet Commercial 53RWEHRF603 Instrucciones De Funcionamiento Originales

EN

Starting the engine

Note
The choke is used for starting the de-
vice when the engine is cold. Some models
have no choke. The engine is automatically
set to the particular starting process. Follow
the separate instructions in the engine oper-
ating manual.
Open the fuel tap (for the left or right fuel tank).
Sit down on the driver's seat.
Switch the parking brake on.
Switch the cutter deck off.
Set the throttle to .
If the engine is cold, pull the choke / set the
throttle to .
Press the ignition key
Insert the ignition key into the ignition lock.
Turn the ignition key to
starts running.
Release the ignition key.
Set the ignition key to
Note
A start attempt should take a maximum of
5 seconds. Wait 10 seconds before trying
again.
Reset the choke / throttle slowly until the engine is
running smoothly.

Stopping the engine

Set the throttle to the middle position.
Let the engine run for approx. 20 seconds.
Set the ignition key to
Remove the ignition key.
Switch the parking brake on.
18
:
until the engine
.
.
Driving
WARNING!
Risk posed by abrupt starting, sudden
stopping and driving at an excessively high
speed.
Risk of accidents
Drive slowly and brake slowly.
Do not drive at excessive speed.
Be particularly careful when reversing.
Never change the direction of travel with-
When entering corners, always reduce
your speed and adjust the speed to the
turning radius (the tighter the corner, the
lower the speed).
Never adjust the driver's seat when in
motion.
Never operate the device without the
rollbar or cutter deck.
Do not operate the device with the rollbar
folded down.
Always wear a seat belt when the rollbar
is folded up.
Do not fasten the seat belt when the
rollbar is folded down.
This appliance turns around its own axis. The rear
wheels serve as turning points. A conventional
device can turn in circles, but not around its own
axis.
The small vehicle length and the ability to turn
around its own axis give this device excellent
manoeuvrability.
This device features in lieu of a steering wheel two
control levers that serve to steer and power the
vehicle. When the control levers are moved to their
maximum positions the wheels rotate at the speed
set at the throttle.
The control lever positions between neutral and
MAX are proportional to the speed set at the throttle.
To familiarise yourself with how to operate the
device (about 30 minutes) you should start the
device on level ground without onlookers.
Note
Before you use the device to mow your
lawn you should familiarise yourself with the
device's new controls. Start the device and
move the accelerator lever to the centre po-
sition (mid engine speed), leaving the PTO
at OFF. Moving the control levers causes
the device to move slowly and you can now
familiarise yourself with the controls.
Operation
769-12264