Operating Controls; Start-Up - Cub Cadet Commercial 53RWEHRF603 Instrucciones De Funcionamiento Originales

EN

Operating controls

Overview
1 Cutting height adjustment lever
2 Clamping screw for drive control lever adjust-
ment
3 Right drive control lever
4 Throttle / choke *
5 Choke *
6 Display cluster *
7 PTO switch
8 Light switch *
9 Ignition lock
10 12 Volt accessory socket *
11 Switch for optional grass catcher *
12 Fuel tap
13 Fuel tank
14 Tank content display *
15 Gear release lever
16 Trailer coupling *
17 Can holder
18 Seat belt
19 Left drive control lever
20 Seat adjustment lever
(* model-dependent)
Note
For reasons of clarity, the rollbar is not
shown.

Start-up

Check:
All protective equipment
The engine oil level (see the engine handbook)
The fuel level
Tyre pressure
The side coverings, accessory equipment, the
Fill up with fuel and check the oil level
Note
the factory – please check the oil, if required
Use unleaded petrol.
Fill fuel tank up to max. 2 cm below the lower
edge of the inlet nozzle.
Seal the fuel tank tightly.
Check the oil level. The oil level must be between
the "Full/Max." and "Add/Min." mark (see also
engine manual).
16
Check tyre pressure
Check the tyre pressure on all wheels and correct
it where necessary (for max. tyre pressure, see
tyre wall).
(depending on the design and model)
Note
Depending on the design, the device may
have an adjustable seat with a built-in pres-
ence sensor and a retractable seat strap.
Sit on the driver's seat.
Press the adjustment lever to the left and keep it
held .
Bring the seat to the desired position
the adjusting lever .
Note
When releasing the adjustment lever, make
sure the seat latches in correctly.
Move the armrests upwards
Turn the adjusting segment into the required posi-
tion :
- 0 = Lowest position
- 3 = Highest position
Move the armrests downwards.
The adjustment mechanism for the weight-
dependent seat suspension allows for adjustment to
the driver's weight of between 56–125 kg.
Increasing the seat hardness / carrying
capacity
Turn the rotary knob in a clockwise direction until
the required seat hardness has been reached
Reducing the seat hardness / carrying
capacity
Turn the rotary knob in an anti-clockwise direc-
tion until the required seat hardness has been
reached .
Setting the drive control levers
Depending on requirements, the drive control levers
can be adjusted higher, lower and longitudinally.
Remove the screws and washers [1]
Push the drive control lever [2] upwards or
screws and washers [1] in another pair of holes in
the mount [3] .
Operating controls
and leave
.
:
.
769-12264
.