Two-Cup Function; Using Steam - Krups ESPRESSERIA AUTOMATIC PREMIUM Manual Del Usuario

IFU KRUPS Nafta_Premium_USA_xxxxxxxx 31/05/10 14:33 Page9
When the machine is plugged in, an initializing cycle is processed. Press the on/off button
and perform a rinsing operation if you wish.
The selection menu will
be displayed.
To stop coffee flowing into the cup, you can either press the button again or turn the rotating button to reduce volume.
Please note : The ground coffee is first moistened with a little hot water after the grinding stage. This is called
"pre-brewing" and it optimizes the brewing process by ensuring that the grounds are evenly wet.
A few moments later, the full brewing cycle begins.
DO NOT REMOVE THE WATER TANK BEFORE THE END OF THE CYCLE (i.e. 15 sec. after coffee stops
flowing).
There is a temperature setting function to control how hot your coffee is (see Settings).
You can use your machine to make 2 cups of coffee or espresso for the 3 following recipes: espresso / strong espresso / cof-
fee by cycling the machine twice. Remember not to remove the cups after the first cycle.
Put two cups under the
coffee outlets.
You can lower or raise the
coffee outlets to suit the
size of your cups.
THE TWO CUP FUNCTION FOR A 'LONG COFFEE' IS NOT AVAILABLE
Steam is used to froth milk (for cappuccino/latte) but can also be used to reheat other liquids. As you need a higher tempera-
ture to produce steam than to make an espresso, the machine runs an additional pre-heating phase for steam.
CAUTION, STEAM CYCLE DOES NOT STOP IMMEDIATELY
All manuals and user guides at all-guides.com
Put a cup under the coffee
outlets.
You can lower or raise the
coffee outlets to suit the
size of your cups.

TWO-CUP FUNCTION

x 2
Select your drink and
confirm by pressing the
OK button twice. A mes-
sage will appear to tell
you that you have
chosen two cups.

USING STEAM

When the screen displays the selection menu, press the "steam" key
inform you that the machine is being pre-heated. Once the pre-heating phase has been
completed, a message will ask you to place a container under the steam nozzle. Press the
"steam" key again to start generating steam. A little water will be produced first and
then steam will start. Use the same button to stop steam generation.
, wait for the end of pre-heating
Use the rotating button
to select your choice
and confirm by pressing
the OK button.
two complete cycles.
9
You can change the
volume of water at any
time using the rotating
knob.
The machine will
automatically
sequence through
. The screen will